Part Nos 501 / 502 / 506 / 571 / 572 / 573
Male versions of Tappex Multisert 001 / 002 / 006 / 071 / 072 / 073

Material: Brass – to BS EN 12164 CW 614N
REACH/RoHS compliant as per the candidate list of substances of very high concern.

Finish: Self-Colour. Special finishes to customer requirements, at extra cost.

Description: The Male Multisert is a press fit insert. Two body length options are available as well as headed and unheaded, the Multisert form may also be reversed to give high pull out performance where access to the rear of the moulding is possible. The part number is defined by the female body size replacing the first 0 with a 5. Special ends to the thread such as dog point or chamfer may also be specified.

Application: For use in thermoplastic materials where the mating component fits flush.

Hole size: Moulded and drilled hole diameters vary dependent upon the nature of the final assembly, component geometry and plastic material. Please consult our technical department for a precise recommendation, to ensure optimum production conditions. Sizes given for the female equivalent body size are relevant.

Installation: This insert is most suitable for press fitting cold. Where heat must be used consideration should be given to the greater mass of the male insert which takes longer to heat up, increasing installation times, and cool down, with the risk of subsequent insert movement.