A barbed, large headed insert available in extra short lengths in a range of thread sizes from M2 to M10.
The Microbarb incorporates all the standard features of the Multisert range but provides the designer and production engineer with an insert pull through applications in thin section materials.
The design incorporates a larger head and barb diameter to provide increased bearing surfaces. For larger thread sizes the back of the head is chamfered to reduce the apparent projection. Maximum thread engagement is achieved by countersinking the limited thread length at only one end.
To provide optimum performance the plastic material section should be designed to be slightly in excess of the Microbarb under-head length. This ensures that upon assembly a clamp with the mating part is achieved, whilst limiting the compression of the plastic
The Microbarb is ideal for use in vacuum formed, rotational moulded and fabricated components.
The Microbarb Multisert has been designed with a larger head and barb diameter to provide increased bearing surfaces in thin section materials. The insert can be pressed-in cold or with heat and is primarily used in a pull through mode in thermoplastics, but it can be used in thermosets with a tensile strength of less than 100Mpa and some degree of resilience.
Brass - to BS EN 12164 CW 614N
REACH/RoHS compliant as per the candidate list of substances of very high concern.
Finish: Self-Colour. Special finishes to customer requirements, at extra cost.
Description: The Microbarb Multisert has larger head and barb diameter to provide increased bearing surfaces.
Application: Designed for use in thin section thermoplastic and some thermoset materials. Ideal for Vacuum formed, Rotational moulded and fabricated parts, where the insert is installed in one direction and the bolt assembled from the other end, giving maximum pull-out loading.
Hole Size: Moulded and drilled hole diameters vary dependent upon the nature of the final assembly, component geometry and plastic material. Please consult our technical department for a precise recommendation, to ensure optimum production conditions.Sizes given are for reference purposes only.
Hole Design: The hole design information is intended to indicate the approximate dimensional requirements for satisfactory installation of the insert. They should not be specified for production tooling without prior consultation with our Application Engineering Department - we accept no responsibility should the use of this information without consultation result in product failure. Please call our application engineers for assistance +44 (0) 1789 206600
Installation: This insert can be used for heat or push in installation depending on the plastic material.
MANY VARIATIONS ON ALL OUR STANDARD PARTS, INCLUDING MALE INSERTS, ARE AVAILABLE. IMPERIAL THREAD SIZES USE NEAREST METRIC EQUIVALENT FOR EXTERNAL DETAIL. PLEASE CONTACT US WITH YOUR REQUIREMENTS.
|Barbs (no. of rows):||2|
|Head Thickness T:||0.55|
|Head Diameter D:||4.90|
|Hole Diameter C:||3.30|
|Hole Depth Y:||1.45|
|Counter Sink B (+0.10):||N/A|
The following are downloads relating to the Microbarb® range, although a downloads may also be applicable to other product ranges. General information can be found on our downloads page.
If you can't find what you are looking for, why not try our chat facility where one of our helpful team can assist you or simply give us a ring on +44 (0) 1789 206600.
There are no downloads related to this product range
You may want to try our downloads page if you are looking for downloadable catalogues and other technical information.